Computing stuff tied to the physical world

RFM12 vs RFM12B

In AVR, Hardware on Apr 29, 2009 at 00:01

Here’s an RFM12 433 MHz module from Pollin, hooked up to an Arduino Duemilanove:

RFM12 (not RFM12B) @ 5V

One major difference between the RFM12 and the RFM12B is that the RFM12 can run at 5V, whereas the maximum operating voltage for the RFM12B is 3.8V (it can withstand up to 6V, which is good to know).

Alas, there seems to be some other difference which eludes me, because the RFM12 hooked up in the above picture only seems to be able to send. The RF12 demo code, which works fine for send and receive on RFM12B’s seems to do something wrong. Same behavior with another RFM12 module – so it looks like this is not due to a broken module. Send works, but nothing is coming in other than occasional garbage data.

The transmit part works fine when sending to an RFM12B, also in OOK mode: the RFM12 successfully controls both 433 and 868 MHz units (KAKU and FS20, respectively). But as packet receiver for other RFM12 or RFM12B modules … no joy so far.

Weird. Tips, anyone? Please let me know.

Update – Thanks to R. Max’s comment below, the problem has been solved: the RFM12 does not support arbitrary 2-byte sync patterns, it has to be 0x2D + 0xD4 – then it works fine!

Update 2 - See also the RFM12 vs RFM12B revisited page for a list of differences.

  1. I guess the problem is that RFM12 has the sync pattern hard coded to “2DD4″. The 2nd sync byte can’t be programmed like in the RFM12B.

  2. YES, THAT WAS IT!

    Thanks, Reinhard, now the code works, yippie!

Comments are closed.