Got some ideas about storing a bit more data than the JeeNode can handle by itself, so here’s a little plug for EEPROM memory chips:
There’s room for up to four chips, i.e. 64 .. 512 Kbyte total. Plenty for a bit of data-logging and for storing compiled sketches / code for remote nodes. Or you could push for new limits with a flash-based O/S :)
This uses an I2C bus: the 6-pin male header on the right plugs into a port and is wired-through to the 6-pin female header on the left, just as with the Expander Plug described a few days ago. The width of this board has been increased so that it can’t be mistaken for a dual-port daughterboard.
Ok, so much for plugs… I need to re-check and finish each one and get a few prototype boards made!