Here’s another display option, using a 16×32 LED panel by Futurlec:
The pattern was hand-coded, to help me figure out which pin is which. The board has 3 16-bit shift registers and corresponding LED drivers. This display can be much brighter than in this picture, I’m using PWM to dim it way down and reduce average current consumption (I think it was 40 mA i.s.o. over 250 mA).
The board is powered from 5V and requires 6 output pins – I’m just using the DIO + AIO pins from three different ports for this test.
Note the 470 µF cap hooked up to the power lines of port 4 to help avoid glitches – switching 32 LEDs on and off at 1 KHz can generate a lot of noise!
Sample code for this display can be found here.
It’d be fun to have this display in a nice enclosure and drive it from packets received over wireless from another JeeNode!