Computing stuff tied to the physical world

Power consumption – baseline

In AVR, Software on May 14, 2009 at 00:01

Ok, first step in lowering JeeNode power consumption is to establish a baseline.

Here is the original code, the first few lines of the loop that is – the rest is the actual sensor readout and calculations, which take about 10 milliseconds:

Picture 1.png

Usage: 9.80 mA (slightly different from yesterday’s post, hooked up to USB from now on).

First change is to make the delay loop explicit:

Picture 2.png

Usage: 10.05 mA – no idea why it’s slightly higher. Anyway 10 mA will be used as baseline – this is the current drawn before any power-saving measures are introduced.

First step: lower power use by putting the processor in idle mode while it’s waiting for the next readout time. Included “avr/sleep.h” and changed the loop to be as follows:

Picture 4.png

Usage: 5.58 mA – it works, cool!

Next idea is to lower the system frequency, but only while waiting – so that readout, processing, and serial I/O remain unaffected:

Picture 5.png

Usage: 1.99 mA – whee! But there is a small gotcha – the system now goes into slow mode before the serial port has finished transmitting. A “delay(3)” at the end (or start!) of the loop is needed to fix this.

For comparison: with just the pre-scaler and no idle mode, usage is 2.15 mA – so the bulk of the savings comes from slowing down the system clock. Idle mode saves roughly 10% at lower frequencies.

One more important saving is possible due to the onboard RFM12B radio module, which powers up with its 10 MHz crystal clock running. Adding a bit more code to access the radio and disable its clock lowers power usage from 1.99 mA to 1.31 mA.

So these three simple measures combined already lead to a 7.5-fold power reduction: “waiting” a bit more carefully and turning off the RFM12B. All without affecting the main application code in any way.

As for the bottom line: putting the processor in power down (from which this code won’t ever wake up) uses 137 µA – and removing the MPU chip brings it to 17 µA. Note that with 140 µA average usage, a JeeNode can run for two years on 3 standard AA batteries.

It ‘s possible to reduce the power consumption from 1.31 mA to the µA range by powering down the processor and using the watchdog timer to wake it up – but that requires another set of changes to code and fuses – stay tuned…

Update – see this more recent post for additional details.

  1. On top of this you could also use the RFM12B wakeup timer mode.

  2. damn that’s small….

  3. Solved – running reliably now @ 3.7 µA :)

Comments are closed.