Yesterday’s post presented a new sketch which did everything the old sketch did, except report motion. The reason was that the requirements for reporting motion are quite different from the rest: it has to be reported right away – using ACKs, time-outs, and retries to make sure this message is properly received.

The latest version of roomNode.pde now adds the missing logic. And it does indeed get a lot messier – doubling the total number of lines in the source code.

Here is the new loop() code:

The key change is that there is now a check for “pir.triggered()” which will be called outside all normal scheduling actions. Note that this code is still using scheduler.pollWaiting(), so the code is still spending most of its time in power-down mode.

Except that now, we’re also setting up a pin-change interrupt for the PIR sensor:

The new code to handle these PIR triggers is as follows:

So instead of folding this complicated case into the rest of the code, when a PIR trigger goes off, we now simply send that packet out and wait for the ACK, repeating it a few times if necessary. The normal measurement and reporting tasks are not affected by any of this, other than that the measurement scheduling is postponed a bit to avoid triggering another report right away.

The new PIR motion sensor turns out to be quite convenient, because it has an on-board trimpot to set the re-trigger timeout. As long as motion is detected more often than this threshold, the PIR output will remain 1, so there is no need to play tricks in software to avoid constant triggers. We’ll get one pin change for the start of motion, and another one when no motion has been detected for a preset amount of time.

Having said that, I’ve implemented a similar re-triggerable one-shot mechanism in software anyway, because my older nodes use the ELV PIR sensor, which send out a pulse for each motion trigger. So all ON pulses within 30 seconds of each other get coalesced into one.

To illustrate that the system is still doing almost nothing most of the time, I added a debug mode which prints a “.” on each iteration of loop(). In normal Arduino sketches, this would cause an incessant stream of characters to be printed out, but in this sketch there are just a few:

Motion detection now works more or less independently of the normal measure / report tasks.

There are still some rough edges, but I expect this new code to perform considerably better in terms of battery lifetime already. The dreaded battery rundown problem when the central node is not reachable should be gone. All that remains are a few attempts (I’ve set it to 5) whenever the PIR sensor turns on or off. In both cases the ACK has to be received within 10 milliseconds – after that the sketch enters power-down mode again.

The new code should also make it much easier to add sensor types (switches, hall-effect, 1-wire, barometer).

FWIW, this code needs 8238 bytes (without serial I/O), so it’ll still easily fit in an ATmega168. Without SHT11 (which uses floating point) that drops to 5682 bytes, including the RF12 driver. How’s that for a WSN node!