A few days ago I posted a new sketch to reprogram an ATmega with the OptiBoot loader when you don’t have an ISP programmer. Worked for me, so I thought… kick it into the world!

Whoops…

First of all, there should have been a warning that if it didn’t work, this would leave you with an unusable ATmega. Never occurred to me, since I have an ISP programmer within reach to recover from such mistakes.

Fortunately, someone on the forum reported that the ATmega can be brought back to life with an old version of isp_repair.pde (which can be found here, BTW).

That’s odd… can’t program with the sketch, but can recover with the same sketch and different data bytes?

Time to dig in. First, I wanted to make sure that the timing was slow enough to work in all cases. Time to fire that logic analyzer up again:

Looks good – since I’m using standard digitalWrite() calls, the pins aren’t toggling very fast at all:

Then it dawned on me:

The lock bits don’t look right: 0xFF – should have been 0xCF (top 2 bits are always 1, i.e. same as 0x0F).

Maybe everything was working, except the setting of the fuse bits? That would explain everything: a new boot loader gets loaded in the top 512 bytes, overwriting parts of the old boot loader, but the fuse bits perhaps wouldn’t get adjusted to just to the new boot address!

I changed a couple of things:

• do the full chip erase before setting the fuse bits
• set the lock bits to 0x0F at the end, i.s.o. 0x3F
• included both bootstraps in the updated sketch
• tri-state the ISP programming pins when done

The erase is needed to recover from a locked fuse state. The programming always took place after the erase, so it went well, but the fuse bits themselves would still be locked while trying to adjust them.

The second step should have been there all along, the way I was doing it the boot section was not protected from overwriting itself. This might explain the occasional report I got of people damaging boot loaders during use.

You can now also adjust the #define OPTIBOOT at the top of the sketch to 0 to revert to the original bootstrap code and fuse settings. So if OptiBoot is not what you want, recompile and restore as needed.

And lastly, the SPI programming pins are now reset to high-impedance after programming, so that the programming connections can be left in place without interfering with the target board.

Here’s the serial output from the updated sketch:

And here’s why it would sometimes have worked: if your ATmega had the lock bits unset (0x3F i.s.o. 0x0F), then the fuse settings would work as intended even with the chip erase in the wrong order. But with a locked setup, not everything would get set to the proper state.

Which goes to show: bugs can bite at any time!

Update – still some issues to iron out (see forum), but it looks like these are more related to OptiBoot than to this bootstrap replacement sketch.

Update #2 – OptiBoot issue solved.